How to use...

PC-Products Liquid Epoxies - PC-Clear

 

Directions for use:

PC-Products' liquid epoxy is supplied in a 1oz syringe. Remove tip from the end of dispenser and depress plunger evenly to dispense equal amounts of resin and hardener. Back off plunger to reduce flow. Mix thoroughly on a flat surface.

Apply the liquid epoxy in any thickness to both sides of surface and bring together firmly. Be careful to insure that ample amount of the liquid epoxy remains between the contact surfaces. To smooth out work, dip tool in lacquer thinner or denatured alcohol.

 

Mixing tips:

Any clean smooth flat surface is an excellent surface for mixing and working from. A small putty knife or flexible artist spatula are great tools for mixing and applying PC-Clear.

Use Denatured alcohol to clean surfaces before applying. Also Denatured alcohol is great for cleaning tools after work is completed.

Surfaces to be bonded must be free of dirt, oil, rust, etc. Denatured alcohol can be used to prep the surface. For best results, rough up the surface to be bonded. After mixing the PC-Clear will run or drip for a few minutes. Support or clamping might be needed during work time (4 minutes).

Note: Most epoxies are temperature sensitive and will cure faster at higher temperatures and slower at cooler temperatures. Speed cure with artificial heat.

 

Product properties:

	PC-Clear
Colour (component A):	Clear
Colour (component B):	Clear
Colour (mixed):	Clear
Work time (70°F):	4 minutes
Tack free cure time:	10 minutes
Cure for service:	1 hour
Maximum cure:	24 hours
Gardner impact resistance:	0.02
Conduction (electric):	Non-conductive
Thermal shock:	Excellent
Toxicity:	Non-toxic once cured
Heat range:	-20 to 200°F